Advanced User's Guide
Table Of Contents
- Advanced User’s Guide MFC-J650DW MFC-J870DW MFC-J875DW
- User's Guides and where do I find them?
- Table of Contents
- 1 General setup
- 2 Security features
- 3 Sending a fax
- Additional sending options
- Additional sending operations
- Polling overview
- 4 Receiving a fax
- 5 Dialing and storing numbers
- 6 Printing reports
- 7 Making copies
- Copy options
- Stop copying
- Improving copy quality
- Enlarging or reducing copies
- Making N in 1 copies or a poster (Page Layout)
- 2 in 1 ID Copy (Page Layout)
- Sorting copies
- Adjusting Density
- Ink Save Mode (MFC-J870DW and MFC-J875DW)
- Thin Paper Copy (MFC-J870DW and MFC-J875DW)
- Book Copy (MFC-J870DW and MFC-J875DW)
- Watermark Copy (MFC-J870DW and MFC-J875DW)
- Remove Background Color
- 2-sided copying
- Setting your changes as the new default
- Restoring all settings to the factory settings
- Saving copy options as a Shortcut
- Copy options
- 8 PhotoCapture Center™: Printing photos from a memory card or USB Flash drive
- 9 Printing photos from a camera
- A Routine maintenance
- B Glossary
- Index
- brother USA/CAN
PhotoCapture Center™: Printing photos from a memory card or USB Flash drive
69
8
a Open the media slot cover.
b Put the memory card or USB Flash drive
in the correct slot.
c Press Scan to Media.
d Load your document.
e Press Options.
f Press a or b to display Auto Crop.
g Press Auto Crop.
h Press On.
i Press OK.
j If you do not want to change additional
settings, press Start to start scanning.
k The number of the scanned documents
appears on the Touchscreen.
Press OK to confirm.
l Press d or c to preview the data for each
document.
m Press Save All to save the data.
NOTE
• Auto Crop is available for paper with
right angles of 90 degrees at all four
corners. If one of the angles is not square,
Auto Crop cannot detect the document.
• If your document is too long or wide, this
setting does not work correctly. The
document has to meet the following
specification: up to 7.7 10.6 in.
(195 270 mm).
If the ratio between the height and width of
the document is more than 1 to 8, this
setting does not work correctly.
• You must place the documents away from
the edges of the scanner glass as shown
in the illustration.
• You must place the documents at least
0.4 in. (10 mm) apart from each other.
• Auto Crop adjusts the skew of the
document on the scanner glass, but if your
document is skewed more than
10 degrees, this setting will not work.
• The ADF must be empty to use the
Auto Crop.
•The Auto Crop feature is available for up
to a maximum of 16 documents
depending on the size of your documents.
IMPORTANT
DO NOT take out the memory card or
USB Flash drive while the machine is
reading or writing to the memory card or
USB Flash drive to avoid damaging the
card, USB Flash drive, or the data stored
on them.










