Quick Setup Guide
Table Of Contents
- Quick Setup Guide MFC-J650DW MFC-J870DW MFC-J875DW
- Start Here
- 1 Unpack the machine and check the components
- 2 Connect the power cord and telephone line
- 3 Install the ink cartridges
- 4 Load plain Letter/A4 paper
- 5 Check the print quality
- 6 Set the date and time
- 7 Choose your language (if needed)
- 8 Choose the correct Receive Mode
- 9 Set your Station ID
- 10 Transmission Verification Report
- 11 Set Tone or Pulse dialing mode (Canada only)
- 12 Set the telephone line compatibility (VoIP)
- 13 Automatic Daylight Saving Time
- 14 Choose your connection type
- For Windows® USB interface users (Windows® XP Home/XP Professional/Windows Vista®/Windows® 7/Windows® 8)
- For Macintosh USB interface users (Mac OS X v10.6.8, 10.7.x, 10.8.x)
- For Windows® wired network interface users (MFC-J870DW/J875DW only) (Windows® XP Home/XP Professional/Windows Vista®/Windows® 7/Windows® 8)
- For Macintosh wired network interface users (MFC-J870DW/J875DW only) (Mac OS X v10.6.8, 10.7.x, 10.8.x)
- For wireless network interface users
- 15 Before you begin
- 16 Choose your wireless setup method
- 17 Setup using the CD-ROM (Windows® and Macintosh)
- 17 Manual setup from the control panel using the Setup Wizard (Windows®, Macintosh and mobile devices)
- 17 One-push setup using WPS or AOSS™ (Windows®, Macintosh and mobile devices)
- Troubleshooting
- Install the drivers & software (Windows® XP Home/XP Professional/Windows Vista®/Windows® 7/Windows® 8)
- Install the drivers & software (Mac OS X v10.6.8, 10.7.x, 10.8.x)
- Install Optional Applications Windows®
- For Network Users
- Other Information
- Consumables
- brother USA/CAN
- Start Here
44
For Network Users
Reset the network settings to factory default
To restore all network settings of the internal Print/Scan server to the factory default, please follow the steps below:
a Make sure the machine is idle, then disconnect all the cables from the machine (except the power cord).
b Press (Settings).
c Press All Settings.
d Press a or b to display Network.
Press Network.
e Press a or b to display Network Reset.
Press Network Reset.
f Press Yes.
g Hold down Yes for two seconds to confirm.
h The machine will restart, re-connect the cables once this is complete.
Entering Text for Wireless Settings
Press to cycle between lower case and upper case.
Press to cycle between letters, numbers and special characters. (The characters available may differ
depending on your country.)
To move the cursor to the left or right, press d or c.
Inserting spaces
To enter a space, press Space.
Making corrections
If you entered a number or a character incorrectly and want to change it, press d or c move the cursor under the
incorrect character, and then press . Enter the correct character. Use d or c to go back or forward to insert a
character.