(EU only) Product Safety Guide HL-L3210CW / HL-L3230CDW / HL-L3270CDW / DCP-L3510CDW / DCP-L3517CDW / DCP-L3550CDW / MFC-L3710CW / MFC-L3730CDN / MFC-L3750CDW / MFC-L3770CDW Brother Industries, Ltd. 15-1, Naeshiro-cho, Mizuho-ku, Nagoya 467-8561, Japan Read this guide before attempting to operate the product, or before attempting any maintenance.
Symbols and Conventions Used in the Documentation The following symbols and conventions are used throughout the documentation. Follow all warnings and instructions marked on the product. WARNING Hot Surface icons warn you not to touch product parts that are hot. WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or serious injuries. CAUTION CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injuries.
Choose a Safe Location for Your Product WARNING Choose a location where the temperature remains between 10°C and 32°C, the humidity is between 20% and 80%, and where there is no condensation. DO NOT place the product near heaters, air conditioners, electrical fans, refrigerators, or water. Doing so may create the risk of an electrical shock, short circuit, or fire, as water may come into contact with the product (including condensation caused by heating/air conditioning/ventilation equipment).
DO NOT put the product in a location that blocks or obstructs any slot or opening in the product. These slots and openings are provided for ventilation. Blocking the machine's ventilation could create a risk of overheating and/or fire. Instead: • Keep a minimum gap around the product as shown in the illustration. Products without scanning function 320 mm 150 mm 150 mm 220 mm Products with scanning function 400 mm 150 mm 150 mm 220 mm • Place the product on a solid level surface.
DO NOT place this product on an unstable cart, stand, or table, particularly if children are expected to be near the product. The product is heavy and may fall, causing injury to you or others and serious damage to the product. For the products with scanning functionality, there is an added risk of injury if the scanner glass should break. Avoid placing your product in a busy area.
There are high-voltage electrodes inside the product. Before you access the inside of the product, including for routine maintenance such as cleaning, make sure you have unplugged the telephone line cord first (MFC models only) and then the power cord from the electrical socket, as well as any telephone/RJ-11 (MFC models only) or Ethernet/RJ-45 cables (Network models only) from the product.
DO NOT drop any metallic hardware or any type of liquid on the power plug of the product. It may cause an electrical shock or a fire. If water, other liquids, or metal objects get inside the product, immediately unplug the product from the electrical socket and contact Brother customer service or your local Brother dealer. This product should be connected to an AC power source within the range indicated on the rating label (You can find the rating label on your machine).
FIRE HAZARDS Failure to follow the warnings in this section may create the risk of a fire. DO NOT use flammable substances, any type of spray, or an organic solvent/liquid containing alcohol or ammonia to clean the inside or outside of the product. Doing so could cause a fire. Instead, use only a dry, lint-free cloth. For instructions on how to clean the product, see the Online User's Guide. DO NOT attempt to operate this product when a paper jam or stray pieces of paper are inside the product.
For users with pacemakers: This product generates a weak magnetic field. If you feel anything wrong with the operation of your pacemaker when near the product, move away from the product and consult a doctor immediately. DO NOT place metal objects, such as clips, staples, or jewellery on the product. If these objects contact the electrical parts inside the product, it may cause a fire or electrical shock. DO NOT place a container holding water or liquid on the product.
(MFC models only) Use caution when installing or modifying telephone lines. Never touch telephone wires or terminals that are not insulated unless the telephone line has been unplugged from the wall socket. Never install telephone wiring during a thunderstorm. Never install a telephone wall socket in a location that is wet or may become wet, for example, near a refrigerator or other appliance that produces condensation. Power Cord Safety: • This product is equipped with an earthed plug.
(DCP-L3510CDW/DCP-L3517CDW/DCP-L3550CDW/MFC-L3710CW/MFC-L3730CDN/ MFC-L3750CDW/MFC-L3770CDW) To prevent possible injuries, at least two people should lift the product by holding it from the front and back.
To prevent injuries, be careful not to put your fingers in the areas shown in the illustrations. HL-L3270CDW For your safety, unplug the product from the electrical socket when it is not used for a long time.
Some products and/or their cartons contain a silica gel pack. DO NOT eat the silica gel pack; throw it away. If you ingest it, seek medical attention immediately. DO NOT attempt to dismantle the toner cartridge. If toner powder should leak out, avoid inhaling it or letting it come in contact with your skin. If either should happen refer to the Safety Data Sheets (SDS) at sds.brother.co.jp/sdsapp/index.html. Keep toner cartridges out of the reach of children.
the power supply may also delete information from the product's memory, and repeated cycling of the power supply can damage the product. • We recommend that you use our genuine toner cartridges to replace cartridges that come with the device. Non-genuine toner cartridges may cause damage to the machine. They may also result in differences in the colours or storage stability. (Not all non-genuine toner cartridges cause these issues.
Avoid using this product during a thunderstorm. There may be a remote risk of electrical shock from lightning. DO NOT use this product to report a gas leak in the vicinity of the leak. Only use the power cord supplied with this product (if included in the box). Disconnect device This product must be installed near an electrical socket that is easily accessible. In case of an emergency, you must unplug the power cord from the electrical socket to shut off the power completely.
Declaration of Conformity (Europe Only) We, Brother Industries, Ltd. 15-1, Naeshiro-cho, Mizuho-ku, Nagoya 467-8561 Japan declare that this product is in conformity with the essential requirements of all relevant directives and regulations applied within the European Community. The Declaration of Conformity (DoC) can be downloaded from our website. Visit support.brother.com and: → select "Manuals" → select your model. Your Declaration will be downloaded as a PDF file.
Recycling Information in Accordance with the WEEE and Battery Directives Product Mark Battery Mark European Union Only The product/battery is marked with one of the above recycling symbols. It indicates that at the end of the life of the product/battery, you should dispose of it separately at an appropriate collection point and not place it in the normal domestic waste stream. Imaging Equipment Voluntary Agreement (This applies to new models placed on the EU market after January 2015.
Mopria® and the Mopria® Logo are registered trademarks and service marks of Mopria Alliance, Inc. in the United States and other countries. Unauthorised use is strictly prohibited. Each company whose software title is mentioned in this manual has a Software License Agreement specific to its proprietary programs. Software Trademarks FlashFX® is a registered trademark of Datalight, Inc. FlashFX® Pro™ is a trademark of Datalight, Inc. FlashFX® Tera™ is a trademark of Datalight, Inc.
Brother Customer Service Customer Service Visit www.brother.com for contact information for your local Brother office. Service Centre Locations For service centres in your country, contact your local Brother Office. Address and telephone contact information for local offices can be found at www.brother.com by selecting your region and country.
Month of publication: 02/2019 D00WET001-01 UK Version A
