User Manual

Table Of Contents
Level 3 Level 4 Level 5 Descriptions
HP Tray Command
- - Select the correct version of HP LaserJet tray
emulation.
Reset Printer
- - Restore the printer settings to the factory settings.
Colour
Correction
Calibration Calibrate
Initiate colour calibration to check and correct
colours.
Reset
Reset the calibration parameters to the default
settings.
Registration
- Align the print position of each colour.
Auto Correction
- Set the machine to perform Colour Calibration and
Registration automatically.
Colour Settings Setting Mode
Select whether to apply the colour print settings of
the machine or the printer driver.
Colour Mode
Select the colour mode.
Improve Grey
Colour
Turn on or off to improve the image quality of
shaded areas.
Enhance Black
Printing
Turn on or off if a black graphic does not print
correctly.
Brightness
Adjust the brightness.
Contrast
Adjust the contrast.
Red
Adjust the red colour.
Green
Adjust the green colour.
Blue
Adjust the blue colour.
[All Settings] > [Network]
Level 3
Level 4 Level 5 Level 6 Descriptions
Wired LAN TCP/IP BOOT Method IP Boot
Tries
Select the Boot method that best
suits your needs.
IP Address
- Enter the IP address.
Subnet Mask
- Enter the Subnet mask.
Gateway
- Enter the Gateway address.
Node Name
- Enter the Node name.
(up to 32 characters)
WINS
Configuration
- Select the WINS configuration mode.
WINS Server Primary
Specify the IP address of the primary
WINS server.
Secondary
Specify the IP address of the
secondary WINS server.
DNS Server Primary
Specify the IP address of the primary
DNS server.
Secondary
Specify the IP address of the
secondary DNS server.
APIPA
- Set the machine to allocate the IP
address from the link-local address
range automatically.
IPv6
- Turn the IPv6 protocol on or off.
Ethernet
- - Select the Ethernet link mode.
619