User Manual

120
NOTE
• If an error message is displayed, press OK
and try again.
(For more information, see Error and
maintenance messages on page 123.)
• If you are using the Windows
®
printer
driver, the driver will get the calibration
data automatically if both Use Calibration
Data and Get Device Data
Automatically are selected. These
settings are enabled by default.
(see Software and Network User's Guide).
• If you are using the Macintosh printer
driver, you must perform the calibration
using the Status Monitor. Open the Status
Monitor, and then select Color
Calibration from the Control menu
(see Software and Network User's Guide).
Colour Registration A
If solid areas of colour or images have cyan,
magenta or yellow fringes, you can use the
auto-registration feature to correct the
problem.
a Press .
b Press Registration.
c Press Yes to confirm.
d The machine will display Completed.
e Press .
Auto Correction A
You can set if the colour correction (Colour
Calibration and Colour Registration) occurs
automatically. The default setting is On. The
colour correction process consumes some
amount of the toner.
a Press .
b Press All Settings.
c Press Printer.
d Swipe up or down, or press a or b to
display Colour Correction.
e Press Colour Correction.
f Press Auto Correction.
g Press On or Off.
h Press .