User Manual

Telephone services and external devices
55
7
Using a non-Brother cordless
external handset 7
If your non-Brother cordless telephone is
connected to the EXT. jack of the machine
(see page 54) and you typically carry the
cordless handset elsewhere, it is easier to
answer calls during the Ring Delay.
If you let the machine answer first, you must
go to the machine so you can press Pickup
to transfer the call to the cordless handset.
Using Remote Codes 7
Fax Receive Code 7
If you answer a fax call on an extension
telephone, you can tell your machine to
receive it by pressing the Fax Receive
Code l51. Wait for the chirping sounds then
replace the handset (see Easy Receive
on page 46).
If you answer a fax call at the external
telephone, you can make the machine
receive the fax by pressing Fax Start and
then pressing Receive.
Telephone Answer Code 7
If you receive a voice call and the machine is
in F/T mode, it will start to sound the F/T ring
(pseudo/double-ring) after the initial ring
delay. If you pick up the call on an extension
telephone you can turn the F/T ring off by
pressing #51 (make sure you press this
between the rings).
If the machine answers a voice call and
pseudo/double-rings for you to take over, you
can take the call at the external telephone by
pressing Pickup.
Changing the Remote Codes 7
The preset Fax Receive Code is l51. The
preset Telephone Answer Code is #51. If you
are always disconnected when accessing
your External TAD, try changing the
three-digit remote codes, for example ###
and 999.
a Press .
b Press All Settings.
c Swipe up or down, or press a or b to
display Fax.
d Press Fax.
e Swipe up or down, or press a or b to
display Setup Receive.
f Press Setup Receive.
g Swipe up or down, or press a or b to
display Remote Codes.
h Press Remote Codes.
i Do one of the following:
 If you want to change the
Fax Receive Code, press Fax
Receive Code. Enter the new
code, and then press OK.
 If you want to change the
Telephone Answer Code, press Tel
Answer. Enter the new code, and
then press OK.
 If you do not want to change the
Codes, go to step j.
 If you want to turn the Remote Codes
Off (or On), press Remote Codes.
Press Off (or On).
j Press .