User Manual
Table Of Contents
- Product Safety Guide
- How to use this guide:
- Symbols and conventions used in the documentation
- Compilation and Publication Notice
- Choose a safe location for your product
- General precautions
- Connecting the product safely
- Servicing the product
- Product Warranty & Liability
- Approval Information (MFC only)
- Declaration of Conformity (Europe only)
- Declaration of Conformity for R&TTE (Radio and Telecommunications) Directive 1999/5/EC (Europe only) (Applicable to models with telecommunications and/or radio interfaces)
- IEC60825-1:2007 Specification (For 220-240V Models Only)
- Wireless LAN (Models with Wireless LAN function only)
- Disconnect device
- Wiring information (U.K. only)
- NFC (Models with NFC function only)
- LAN connection
- Radio interference
- Recycling information in accordance with the WEEE and Battery Directives
- International ENERGY STAR® Qualification Statement
- Trademarks
- Open Source Licensing Remarks
- Copyright and License
- Other Information
- Brother customer service
- Unlawful use of copying equipment (MFC and DCP only)
15
IEC60825-1:2007 Specification (For 220-240V Models Only) 1
This product is a Class 1 laser product as defined in IEC60825-1:2007 specifications. The label
shown below is attached in countries where required.
Internal Laser radiation 1
Wave length: 770 - 800 nm
Output: 25 mW max.
Laser Class: Class 3B
WARNING
Use of controls, adjustments or performance of procedures other than those specified in this
manual may result in hazardous radiation exposure.
Wireless LAN (Models with Wireless LAN function only) 1
This Printer/Multifunction Printer supports Wireless LAN.
Disconnect device 1
CAUTION
This product must be installed near an electrical socket that is easily accessible. In case of
emergencies, you must disconnect the power cord from the electrical socket to shut off power
completely.
Wiring information (U.K. only) 1
If you need to replace the plug fuse, fit a fuse that is approved by ASTA to BS1362 with the same
rating as the original fuse.
Always replace the fuse cover. Never use a plug that does not have a cover. If in any doubt, call
a qualified electrician.
Warning -This product must be earthed.
The wires in the mains lead are coloured in line with the following code:
This product has a Class 3B Laser Diode which emits
invisible laser radiation in the Scanner Unit. The Scanner
Unit should not be opened under any circumstances.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT