User Manual
Table Of Contents
- Product Safety Guide
- Compilation and Publication Notice
- Choose a Safe Location for Your Product
- Connect the Product Safely
- Use the Product Safely
- Important Information for Australia
- Important Information for New Zealand
- Important Information for Some Countries
- Product Warranty & Liability
- Declaration of Conformity (Europe Only)
- EU Declaration of Conformity for RE Directive 2014/53/EU (Europe Only) (Applicable to Models with Radio Interfaces)
- IEC60825-1:2014 Specification (For 220 V - 240 V Models Only)
- Wireless LAN (Models with the Wireless LAN Function Only)
- NFC (Models with the NFC Function Only)
- LAN Connection (Models with the Wired LAN Function Only)
- For WLAN models (Taiwan only)
- Compliance Statement of Wireless equipment (Thailand only)
- Recycling information in accordance with the India E-Waste (Management) Rules (India only)
- Declaration of the Presence Condition of the Restricted Substances Marking (Taiwan Only)
- Trademarks
- Brother Customer Service
- Unlawful Use of Copying or Scanning Equipment (Products with the scanning function only)
- Disclaimer
NFC (Models with the NFC Function Only)
This Printer/Multifunction Printer supports NFC (Near Field Communication).
• Frequency band(s): 13.553 MHz - 13.567 MHz
Maximum radio-frequency power transmitted in the frequency band(s): Less than 111.5
dBuV/m at 10 m
LAN Connection (Models with the Wired LAN Function Only)
CAUTION
DO NOT connect this product to a LAN connection that is subject to over-voltages.
For WLAN models (Taiwan only)
Caution!
Administrative Regulations on Low Power Radio Waves Radiated Devices
Article 12: Unless granted permission by Taiwan DGT, any company, enterprise or user is not
allowed to change the frequency, enhance the transmitting power or alter the original design
characteristics or operating functions of an approved low-power radio frequency device.
Article 14: Low-power radio frequency devices shall not influence aircraft security or interfere
with legal communications. If such interference occurs, the low-power radio frequency device
must immediately cease operations and may not be resumed until the interference problem has
been resolved. The above-mentioned “legal communications” is defined as radio communication
operations that conform to the Telecommunications Act. Low-power radio-frequency devices
must accept any interference received from legal communications, and Industrial, Scientific and
Medical (ISM) radio wave devices.
Avoid affecting the operation of nearby radar systems.
Compliance Statement of Wireless equipment (Thailand only)
This telecommunication equipment conforms to the standard or technical requirements of
NBTC.
20