Product Safety Guide
Table Of Contents
- Product Safety Guide
- Compilation and Publication Notice
- Choose a Safe Location for Your Product
- Connect the Product Safely
- Use the Product Safely
- Regulations
- Standard Telephone and FCC Notices (Models with the fax function only)
- Federal Communications Commission (FCC) Supplier's Declaration of Conformity (USA Only)
- RF Exposure Notice (USA or Canada Only) (Wireless Models Only)
- Wireless Connection (Mexico Only) (Wireless Models Only)
- Industry Canada Compliance Statement (Canada Only)
- EQUIPMENT ATTACHMENT LIMITATIONS (Canada Only) (Models with the fax function only)
- Laser Safety (for 110V - 120V Models Only)
- FDA Regulations (for 110V - 120V Models Only)
- For Use in the USA or Canada Only
- LAN Connection (Models with the Wired LAN Function Only)
- International ENERGY STAR® Qualification Statement (USA and Canada Only)
- Trademarks
- Legal Limitations for Copying or Scanning (Products with Scanning Function Only)
- To request a printed version of the Online User's Guide, please contact us at:
- Disclaimer
Federal Communications Commission (FCC) Supplier's
Declaration of Conformity (USA Only)
Responsible Party: Brother International Corporation
200 Crossing Boulevard
Bridgewater, NJ 08807-0911 USA
TEL: (908) 704-1700
declares, that the products
Product Name: Color Laser Printer
Model Numbers: HL-L9410CDN/HL-L9430CDN/HL-L9470CDN/HL-EX470W
Product Name: Multi Function Printer
Model Numbers: MFC-L9610CDN/MFC-L9630CDN/MFC-L9670CDN/MFC-EX670W
comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to correct the interference
at his own expense.
(Wireless network models only)
This transmitter must not be co-located or operated in conjunction with any other antenna or
transmitter.
IMPORTANT
• Changes or modifications not expressly approved by Brother Industries, Ltd. could void the
user’s authority to operate the equipment.
Compliance with FCC requirement 15.407(c)
Data transmission is always initiated by software, which is the passed down through the MAC,
through the digitaland analog baseband, and finally to the RF chip. Several special packets are
initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF
transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on
only while one of the aforementioned packets is being transmitted. In other words, this device
automatically discontinue transmission in case of either absence of information to transmit or
operational failure.
Frequency Tolerance: 20 ppm
The FCC ID can be found on the label attached to the Wireless Module.
17