User Guide

Table Of Contents

Home > Machine Settings > Change Machine Settings from the Control Panel > General Settings > Set

Your Station ID

Set Your Station ID

Set the machine's Station ID if you want the date and time to appear on each fax you send.

NOTE

(USA only)

The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer or

electronic device to send any message via a telephone fax machine unless such messages clearly contain,

in a margin at the top or bottom of each transmitted page, or on the first page of the transmission, the date

and time it is sent and an identification of the business or other entity or other individual sending the message

and the telephone number of the sending machines or such business, other entity or individual. To program

this information into the fax machine, see Set the date and time and Set your Station ID.

1. Press [Settings] > [All Settings] > [Initial Setup] > [Station ID].

2. Press [Fax].

3. Enter your fax number (up to 20 digits) on the touchscreen, and then press [OK].

4. Press [Name].

5. Enter your name (up to 20 characters) using the touchscreen, and then press [OK].

• Press to cycle between letters, numbers and special symbols. (The available characters may

differ depending on your country.)

• If you entered an incorrect character and want to change it, press d or c to move the cursor to it. Press

and then enter the correct character.

• To enter a space, press [Space].

6. Press .

Related Information

• General Settings