User Manual

Software
Printing
Print type:
Print condition:
Bit image only
Auto tape cut: ON / OFF
Left and right margins: small, medium, large, none
Buffer
*Print buffer (normal):
Approximately 30KB (27 cm)
**Reception buffer;
512B
Transmission
Baud rate;
9600 (fixed); data reception at 9600 bps
control
Busy output: Xon/off and DTR
Length:
8 bits (fixed)
Parity:
none (fixed)
Commands
CR
Carriage return
LF
Line feed
FF
Print command
CTRL-Z
Print command with feed
ETX
Same as CTRL-Z
ESC J
Line feed
ESC$ Absolute position assignment
ESC\
Relative position assignment
ESC*
**
Bit image selection
ESC@
Initialization
ESCiS Status request
ESCiM
Mode specification
ESCiD
Print density control
ESCiP Printing command for continuous page
Others
Tape cut ON / OFF
Tape end detection
Cutter error detection
Tape type / Tape detection (with or without)
*Print buffer: stores the print image that is printed by the thermal head
**Reception buffer: stores a received interface data temporarily until it is sent to the print
buffer
13