Operation Manual

7
z GETTING STARTED
Connecting to the Power Supply
1 Connect the AC power cord to the QL-500/550.
2 Plug the AC power cord into a standard electrical outlet.
Connecting to the Power Supply
• Check that the electrical outlet is 220 - 240 V before
inserting the plug.
• Remove the AC power cord from the electrical outlet after
you have finished using the QL-500/550.
• Do not pull the cord when removing it from the electrical
outlet. The wire in the cord may become damaged.
Do not connect the QL-500/550 to the USB port of your personal computer yet.
Do not connect the QL-500/550 to your personal computer until
directed to do so when installing the printer driver. If the QL-
500/550 is connected to a personal computer that does not have
the printer driver software installed, the dialog box shown here
will appear. Click [Cancel], remove the USB cable, and then
install the printer driver software.
Refer to “Installing the Software” on page 11.