Operation Manual

19
z INSTALLING SOFTWARE
Installing the Software
8 When the Driver Setup dialog box
instructs you to connect the QL-500/
550, plug the connector on the USB
cable into the USB port on the back of
the QL-500/550.
9 Check that the QL-500/550 is turned on,
and then plug the connector on the USB
cable into the USB port on your
personal computer.
The Add New Hardware Wizard dialog box
appears.
10 Click [Next].
The next Add New Hardware Wizard
dialog box appears.
11 Click [Next].
The next Add New Hardware Wizard dialog
box appears.
When connecting the QL-500/550 to a
personal computer via a USB hub, a proper
connection may not be possible due to the
type of hub used. If this occurs, connect the
QL-500/550 directly to the personal
computer.
The name of the detected hardware shown
in the dialog box may vary depending on
your operating environment.