Instruction manual

12
If the LCD is hard to see when the power is turned on
UTILITY
STITCH
CHARACTER
DECORATIVE
STITCH
EMBROIDERY
EMBROIDERY
EDIT
OPERATION
GUIDE
MEMORY
RECALL
1. While touching the LCD (anywhere is OK),
turn the power off and then back on again.
* The START/STOP button will not illuminate at
this time.
UTILITY
STITCH
CHARACTER
DECORATIVE
STITCH
EMBROIDERY
EMBROIDERY
EDIT
OPERATION
GUIDE
MEMORY
RECALL
2. Touch any one of the lower three selection
keys (EMBROIDERY EDIT, OPERATION
GUIDE or MEMORY RECALL). The LCD will
become darker each time one of these keys is
touched. If you would like to make the LCD
lighter, touch any one of the upper three
selection keys (UTILITY STITCH,
CHARACTER/DECORATIVE STITCH or
EMBROIDERY).
3. After you have finished adjusting, turn the
power off and back on again once more.
Adjusting the brightness of the LCD.
1. Touch the “OPERATION GUIDE” key.
2. Touch the “BRIGHTNESS OF LCD” key.
1 Touch this key to make contrast less (lighter).
2 Touch this key to make contrast greater
(darker).
3 Touch this key to return to the screen which
was previously being displayed.
12
3