Instruction manual

4. Guide the thread through the small hole in the side of the

bobbin from the inside. Place the bobbin on the bobbin

winder shaft. While holding the thread end, push the bobbin

winder shaft to the right.

1 Spring on the shaft

2 Groove of the bobbin

* Align the groove of the bobbin with the spring on the shaft.

5. While holding the thread end, press the “START/STOP”

button. Wind the thread a few times around the bobbin and

press the “START/STOP” button again.

Trim the excess thread from the top of the bobbin after the

machine stops.

6. Set the speed to maximum.

7. Press the “START/STOP” button. The machine will stop

automatically when the bobbin is full. Press the

“START/STOP” button to stop at any time or when the

bobbin has stopped moving and the motor is still running.

8. Push the bobbin shaft to the left. Remove the bobbin.

9. Set the bobbin into the shuttle as shown on the next page.