Use and Care Manual

Upper Threading
GETTING READY
17
1
o
Lower the needle threader lever on the left side of the
machine as much as possible to make the hook turn.
1 Needle threader lever
2 Needle
3 Hook
p
Raise the needle threader lever slowly.
q
Carefully pull the end of thread that was passed
through the eye of the needle.
If the needle was not completely threaded, but a loop in
the thread was formed in the eye of the needle, carefully
pull the loop through the eye of the needle to pull out
the end of the thread.
r
Raise the presser foot lever, pass the end of the thread
through and under the presser foot, and then pull out
about 5 cm (approx. 2 inches) of thread toward the
rear of the machine.
s
Press to unlock all keys and buttons.
Note
• If the needle is not raised to it's highest position, the
needle threader cannot thread the needle. Turn
handwheel counterclockwise until the needle is at its
highest position. The needle is correctly raised when the
mark on the handwheel is at the top, as shown under
step
c on page 15.
1
2
3