Operation Manual

126
f
Wind the thread clockwise around the bobbin 4 or 5
times, as shown in the illustration.
g
Pass the end of the thread through the guide slit in the
bobbin winder seat, and pull the thread. The cutter will
cut the thread.
1 Guide slit
2 Bobbin winder seat
h
Slide the bobbin holder, until it clicks into place.
1 Bobbin holder
i
Press the main power switch to start winding the
bobbin.
 Start winding the bobbin.
j
The bobbin will stop rotating automatically when it is
done winding, and the bobbin holder will return to its
original position.
k
Remove the bobbin.
Note
• Be sure to follow the procedure described. If the
bobbin is wound without the thread being cut with
the cutter, when the bobbin thread runs low, the
thread may become tangled around the bobbin
and cause the needle to break.
Note
• When removing the bobbin, do not pull on the
bobbin winder seat. Doing so could loosen or
remove the bobbin winder seat, resulting in
damage to the bobbin winder.