Operation Manual

152
32 OK to recall and resume previous memory? This message is displayed when the machine is turned off, then on again
before embroidering is completed. Touch to resume embroidering.
If the embroidering screen was displayed before the machine was turned off,
back up several stitches, and then continue embroidering. (page 92)
33 OK to revert to previous color changes?
This message is displayed when is touched while thread colors are
being changed.
34 OK to separate the combined border pattern? This message is displayed when a combined border pattern is being rotated
in the embroidering settings screen.
35 Panel communication error. When this message is displayed, consult your nearest authorized Brother
dealer.
36 Pattern extends to the outside of embroidery frame.
Add no additional characters.
This message is displayed when the entered character patterns exceed the
width of the embroidery frame.
37 Pattern extends to the outside of embroidery frame.
This function cannot be used at this time.
This message is displayed when the font of the character pattern is changed
to one with a larger size, causing the pattern to extend beyond the
embroidery frame.
38 Picker error This message is displayed when the thread picker (page 35) does not
operate correctly. Remove the thread entangled on the thread picker, and
then touch .
39 Please set up the “Thread antenna” This message is displayed when thread guide assembly support is not
prepared. Prepare the thread guide assembly. (page 19)
40 Power supply voltage error.(24V high) When this message is displayed, consult your nearest authorized Brother
dealer.
41 Power supply voltage error.(24V low) When this message is displayed, consult your nearest authorized Brother
dealer.
42 Power supply voltage error.(40V high) When this message is displayed, consult your nearest authorized Brother
dealer.
43 Power supply voltage error.(40V low) When this message is displayed, consult your nearest authorized Brother
dealer.
44 Press the unlock key to unlock the machine. This message is displayed when the thread trimming button is pressed
before the machine is unlocked. Touch to use the thread
trimming function.
45 Preventive maintenance is recommended. This message is displayed when the machine needs maintenance.
(page 143)
46 Select a pattern. This message is displayed when there is no embroidery pattern selected and
the “Start/Stop” button is pressed.
47 Set the clock. This message is displayed when the time/date is not set. Set time/date.
(page 23)
48 Stop while needle bar case transferring. This message is displayed when the machine has stopped while the needle
bar case is moving. Touch to automatically reset the needle bar
case.
Error messages Cause/solution