Operation Manual

Resume embroidering after turning off the

machine

In either of the following cases, the remaining stitches of the

embroidery are stored in the machine’s memory.

• If the machine’s power switch is pressed to turn off

before stopping embroidering:

Cut the thread before the machine’s main power

switch is turned off, otherwise the thread may be

pulled or may catch when the carriage returns to its

initial position after the machine is turned on again.

• If the machine was accidentally turned off, for

example, due to a power outage, while it was

embroidering:

The remainder of the embroidery can be performed

when the machine is turned on again; however, some

of the stitches that were already embroidered may be

embroidered again.

1 Cancel embroidering and display the pattern type

selection screen to select a new pattern.

2 Continue embroidering.

 The embroidering screen displayed before the

machine was turned off appears.

Note

• You may need to advance or reverse through the

stitches to get to the correct needle drop position.