Raster Command Reference

Raster Command Reference
- 33 -
4. Printing Command Details
ESC i M Various mode settings
ASCII: ESC i M {n1}
Hexadecimal: 1B 69 4D {n1}
Parameters
Definitions of {n1}
The meaning of each bit in a 1-byte parameter is described below.
0 ～ 5bit：Not used
6bit：Auto cut 1. Automatically cuts 0. Does not automatically cut
7bit：Mirror printing 1. Mirror printing 0. No mirror printing
ESC i K Advanced mode settings
ASCII: ESC i K {n1}
Hexadecimal: 1B 69 4B {n1}
Parameters
Definitions of {n1}
The meaning of each bit in a 1-byte parameter is described below.
0 ~ 2bit：Not used
3bit：No chain printing
When printing multiple copies, the labels are fed after the last one is printed.
1．No chain printing（Feeding and cutting are performed after the last one is printed.）
0：Chain printing（Feeding and cutting are not performed after the last one is printed.）
4bit：Special tape (no cutting)
Labels are not cut when special tape is installed.
1.Special tape (no cutting) ON 0:Special tape (no cutting) OFF
5 ~ 6bit：Not used
7bit：No buffer clearing when printing
The expansion buffer of the machine is not cleared with the “no buffer clearing when printing”
command.
If this command is sent when the data of the first label is printed (it is specified between the
“initialize” command and the print data), printing is possible only if a print command is sent with the second
or later label.
1.No buffer clearing when printing ON 0.No buffer clearing when printing OFF