Use and Care Manual
Table Of Contents
- Introduction
- Safety Precautions
- General Precautions
- Power Supply and Tape Cassette
- Keyboard
- LCD
- Initial Settings
- Entering Text and Accented Characters
- Adding Symbols
- Designing Labels
- Adding Deco Mode Patterns
- Printing Labels
- 1. Insert the label, with the printed surface facing down,as far as possible into the built-in peeler.
- 2. Fold back the label to the right and quickly pull out thelabel. The end of the backing is slightly separatedfrom the label.
- 3. Peel the printed label away from the label backing andapply the printed label.
- Saving Label Files
- Resetting the label maker
- Troubleshooting
- Specifications
Power Supply and Tape Cassette
Remove the cassette cover by pressing the
above indicated area.
If you already installed a tape cassette, remove it by
pulling it straight up. If you already installed batteries,
remove them as well.
• Make sure the power is turned off when replacing
batteries or tape cassettes.
Insert a tape cassette, making sure it snaps
into place.
• Make sure the end of the tape feeds under the tape
guides.
• Use Genuine Brother P-touch M tapes with this label
maker.
Insert four new AAA alkaline batteries
(LR03), making sure their poles point in the
correct directions.
• Always replace all four batteries at the same time with
brand new ones.
• Remove the batteries if you do not use the label
maker for an extended period of time.
Insert the two hooks at the bottom of the
cassette cover into the slots on the label
maker (1), and then close the cover
securely until it snaps into place (2).
After you have installed the tape, feed the tape (see
“Feeding”) once, and then push in the tape cutter lever
to cut the tape.
1
Print head
Tape cutter lever
Cassette
cover
2
Cutter’s
edge
Tape
exit slot
Tape guide
End of tape
3
1
2
4