Use and Care Manual
Table Of Contents
- Introduction
- Safety Precautions
- General Precautions
- Power Supply and Tape Cassette
- Keyboard
- LCD
- Initial Settings
- Entering Text and Accented Characters
- Adding Symbols
- Designing Labels
- Adding Deco Mode Patterns
- Printing Labels
- 1. Insert the label, with the printed surface facing down,as far as possible into the built-in peeler.
- 2. Fold back the label to the right and quickly pull out thelabel. The end of the backing is slightly separatedfrom the label.
- 3. Peel the printed label away from the label backing andapply the printed label.
- Saving Label Files
- Resetting the label maker
- Troubleshooting
- Specifications
Keyboard
DECO MODE key
Preview key
Print key
Character key
Num Lock key
Shift key
Symbol key
Caps key
Cursor key
Function key
Cursor key
Power key
Backspace key
Enter key
Shift key
Accent key
Space key
Initial Settings
1 Turn on your label maker.
Supply power using four AAA batteries, and then press
to turn the power on.
2 Set the language.
The default setting is [English].
[Language]
[English/Español/Français/
Italiano/Nederlands/Norsk/Português/
Svenska/Türkçe/Dansk/Deutsch]
• You can also display [Language] by pressing and
at the same time.
3 Set the unit of measurement.
The default setting is [inch].
[Unit]
[inch/mm]
• You can also display [Unit] by pressing and .
NOTE
• The label maker automatically turns off if no keys are
pressed within five minutes.
• To cancel operations, press .
• To reset the label maker back to factory settings, see
“Resetting the label maker”.
LCD
NOTE
The LCD displays one row of 12 characters; however, you can enter up to 80 characters in length.
Width
Bold
Cursor
Num Lock
Caps
Label Length
Frame
Underline
Italic
Vertical
Outline
Shadow
Size