Instruction Manual for Stamp Starter Kit

ManualsBrandsBrother ManualsCutting MachineSDX230D

Table Of Contents

You can cut the stamp sheet with your cutting machine to create original stamps.

● Do not fold or bend the stamp sheet.

● For detailed instructions on using the cutting machine, refer to the Operation Manual supplied with it.

● Do not store stamp sheets or acrylic blocks in an environment exposed to direct sunlight or extremely low or extremely high

temperatures.

● The contents of this document are subject to change without notice.

● The screens in this manual are for illustration purposes only and may differ from the actual screens.

After purchasing this kit, check the contents.

*1 This accessory is consumable. After you have used it all, purchase CASTPS1(stamp sheets). To purchase options, contact the retailer

where this kit was purchased.

Stamp Starter Kit

About Stamp Starter Kit

Precautions

Accessories

ABCD

Name

Stamp sheet

5.9" × 7.8" (150 mm × 200 mm) : 3 pieces

B Acrylic block 2.9" × 3.9" (75 mm × 100 mm)

C Activation card for access to 50 stamp patterns

DInsertion

Version 0

Summary of content (4 pages)

PAGE 1
EN Stamp Starter Kit About Stamp Starter Kit You can cut the stamp sheet with your cutting machine to create original stamps. Precautions ● ● ● ● ● Do not fold or bend the stamp sheet. For detailed instructions on using the cutting machine, refer to the Operation Manual supplied with it. Do not store stamp sheets or acrylic blocks in an environment exposed to direct sunlight or extremely low or extremely high temperatures. The contents of this document are subject to change without notice.
PAGE 2
Activating the Stamp Patterns on CanvasWorkspace CanvasWorkspace has template images that can be used immediately. a From a computer, log in to CanvasWorkspace. (http://CanvasWorkspace.Brother.com) • New users should create a free account. b Click c Click . d at the top right of the Web page. Type in the activation code on the included card for activation code, and then click . • Scratch off the silver part of the card and reveal the activation code.
PAGE 3
Retrieving the Stamp Pattern on the Machine For detailed instructions on using the cutting machine, refer to the Operation Manual supplied with it. a Remove clear vinyl backing from one side of the stamp sheet. Place the stamp sheet with the remaining backing face up on the standard tack adhesive mat. At that time, stretch the sheet so that no bubbles remain. c Retrieve the pattern on the cutting machine. d Touch the "Test" key to perform test cut.
PAGE 4
f Peel the stamp sheet off the mat, and then check that the test pattern has been cut out. Note • After use, wipe off the ink on the cut-out stamp sheet and acrylic block with a damp cloth or tissue, and then store them after they have dried. • When the leftover stamp sheet is used, it may curl up in the machine. After cutting out the pattern, use scissors to cut around the pattern to clean it up. g Touch the "Start" key to start cutting the stamp pattern.