Instruction Manual for Embossing Tool Set

5
hTouch the "Test" key to make a trial embossing. Check the
result of the test embossing, and if there are no problems,
touch the "Start" key.
• If the desired embossing effect is not achieved, adjust the
embossing pressure. The embossing effect differs depending on
the type and thickness of the material.
• Some materials may tear if the embossing pressure is too strong
or the embossing speed is too fast.
i Use the spatula to carefully peel the material from the
embossing mat.
• Always remove the embossing tool holder from the carriage
after use and close the front tray of the machine.
i(With metal sheets) Remove the metal sheet (with the
protective sheets attached) from the embossing mat, and
then peel both of the protective sheets from the metal
sheet by using the tabs.
• When peeling the metal sheet from the protective sheets, do
not touch the edges of the metal sheet, otherwise injuries may
result.
1. Embossing is not clear.
• If the embossing depth is insufficient, increase the embossing
pressure.
• If the edges are not clear, decrease the inward offset on the
region emboss settings screen.
However, if the offset is too small, embossing cannot be
completed correctly.
2. The material tears.
• If the material tears, decrease the embossing pressure.
If you need additional help, the Brother Solutions Center offers the
latest FAQs and troubleshooting tips. Visit us at "http://s.brother/
cfoag/".
Troubleshooting