User Manual

Easy

Designed for enthusiasts — by enthusiasts. This free project sheet is brought to you by Brother

International Corporation. For more projects, tips and inspiration, visit the Stitching Sewcial blog

at blog.brothersews.com, or follow us: /brothersews

Materials

Project Directions

• Pacesetter Lightweight Water Soluble Stabilizer (SA540)

• Brother embroidery thread

• Brother SE600 2-in-1 Sewing and Embroidery machine

Cut two pieces of lightweight water-soluble

stabilizer several inches larger than your

hoop. Place both pieces of stabilizer in your

embroidery hoop. The stabilizer should be ‘taut

like a drum’ in the hoop. Tighten the screw at

the bottom of the hoop.

Set up your machine to embroider. You will use the same embroidery thread in your top thread

and in your bobbin. Take your desired embroidery thread, and wind a bobbin with this thread.

Freestanding

Lace Star Ornament

Create a beautiful lace

ornament with your Brother

embroidery machine! You’ll

stitch this built-in design on

two layers of water-soluble

stabilizer, then rinse the design

in water, which will then

leave only the thread. These

ornaments make perfect gifts

for everyone on your list.

PAGE 1

PAGE 1
Freestanding ment Lace Star Orna Create a beautiful lace ornament with your Brother embroidery machine! You’ll stitch this built-in design on two layers of water-soluble stabilizer, then rinse the design in water, which will then leave only the thread. These ornaments make perfect gifts for everyone on your list.
PAGE 2
Freestanding Lace Star Ornament Project Directions (cont’d.) 3 Select a Star design (either design 018 or 019) from the built-in embroidery designs in your machine, and press the green ‘Go’ button. 4 Once the design has finished stitching, 5 Cut out the design from the stabilizer. remove the hoop. PAGE 2 Designed for enthusiasts — by enthusiasts. This free project sheet is brought to you by Brother International Corporation.
PAGE 3
Freestanding Lace Star Ornament Project Directions (cont’d.) 6 Submerge the design in warm water for 2-5 minutes, until the stabilizer has completely dissolved. 7 Use thread or ribbon to tie through the top hole of your star ornament. This project created by Laura Pifer Laura is the blogger and designer of the DIY fashion blog Trash to Couture. Trash to Couture was created in 2010 to inspire a less wasteful approach to the mass-produced fashion mainstream through DIY tutorials and repurposed fashions.