user manual

BEFORE EMBROIDERING

B-62

Hold the embroidery foot in place with

your right hand, and then use the included

screwdriver to securely tighten the presser

foot holder screw.

Plug the connector of the embroidery foot

“W+” with LED pointer into the jack on the

back of your machine.

Press to unlock all keys and

buttons.

→ All keys and operation buttons are unlocked, and

the previous screen is displayed.

■ Checking the Needle Drop Point

With the Embroidery Foot “W+”

with LED Pointer

Before beginning to embroider when using the

embroidery foot “W+” with LED pointer, carefully

read the procedures described in the “Embroidery”

and “Embroidery Edit” chapters.

After the embroidery frame is attached,

press in the embroidery screen.

→ The LED pointer indicates the needle drop point.

* The LED pointer turns off automatically by lowering

the presser foot or returning to the previous page.

CAUTION

• Use the included screwdriver to firmly tighten

the screw of the embroidery foot. If the screw

is loose, the needle may strike the presser foot

and possibly cause injury.

Memo

• When the LED pointer is turned on, the

presser foot height is automatically adjusted

according to the fabric thickness.

• If is pressed again, the fabric thickness

is remeasured and the presser foot is set to

the optimum height.

Note

• With thick elastic fabric, the position will be

misaligned only at raised parts in the fabric.

In this case, manually adjust the position

according to the thickness of the fabric.

• With fabric that has a very uneven surface

such as quilting, the position is not correctly

aligned. In this case, the pointer indication

should be used only as a reference.