Owner's Manual

Programmer
138
Chapter 3 Programming with Command Function
2
Inputting the end code
1. Press
E
1
1 1
.
The work clamp returns to the start position.
3
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
4
Ending program
1. Press
P
.
Multiple stitch
This section describes programming of a multiple
stitch. Refer to the example on the left.
Programming can be started from either inside or outside line. Embroidering is carried out in the sequence of
programming.
Embroidering direction depends on programming sequence.
When embroidering direction should be changed at a sharp angle, a split should be provided in the vicinity of the
direction change point for finishing the multiple stitch in relatively uniform conditions.
Up to 200 points can be specified for one side. If you attempt to input 201 or more points, the needle point is
automatically returned to the previous points. In that case, start inputting points of the outside (or the inside) line,
or reconsider point input positions or pattern.
1
Creating a stitch pattern
1. Create a pattern in consideration of the most
inside and outside lines for a multiple stitch.
The two lines should be spaced uniformly.
Should be spaced
uniformly.
Outside line
Inside line