Owner's Manual

Programmer
128
Chapter 3 Programming with Command Function
3
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
4
Ending program
1. Press
P
.
Curve
A pattern with curves is programmed.
Be sure to press
L
7
8 9
for a split at corner points C or E. If a split is not made, the corner will be round.
When a split is made When a split is not made
More intermediate points such as points B, D, F or G will create smooth curves.
1
Programming
1. Press
P
.
The work clamp moves to the home position and the
programmer screen is displayed.
2. Move the work clamp with . Press
L
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.