Owner's Manual

Programmer
131
Chaprter 3 Programming with Command Function
2
Inputting the end code
1. Press
L
at the last stitch and press
E
1
1 1
.
The needle moves to points G and H.
3
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
4
Ending program
1. Press
P
.
Feed
After thread breaking, a feed is set for continuous
sewing with the work clamp in position.
The example in the left is used for explanation of
programming pattern 2 with a feed after pattern 1.
1
Programming
1. Press
P
.
The work clamp moves to the home position and the
programmer screen is displayed.
2. Move the work clamp with . Press
L
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
Pattern 1
Pattern 2