Owner's Manual

Programmer
132
Chapter 3 Programming with Command Function
3. Program pattern 1.
4. Input point B and press
F
.
5. Move the work clamp with
. Press
L
when the needle point is at point C of the
pattern.
6. Program pattern 2.
2
Inputting the end code
1. Press
L
at the last stitch and press
E
1
1 1
.
The work clamp returns to the start position.
3
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
4
Ending program
1. Press
P
.
Pattern 1
Pattern 2