Owner's Manual

Programmer
134
Chapter 3 Programming with Command Function
2
Inputting the end code
1. Press
L
at the last stitch and press
E
1
1 1
.
The work clamp returns to the start position.
3
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
4
Ending program
1. Press
P
.
Symmetrical pattern
A pattern symmetric to the X axis or the Y axis is
programmed. After programming the pattern, select
the symmetrical pattern type to complete the pattern.
The example in the left is used for explanation of
programming symmetric to the Y axis.
The following symmetrical pattern types are available:
Turnover
Use command
L
4
4 3
.
Symmetric to X axis
Use command
L
4
4 1
.
Symmetric to Y axis
Use command
L
4
4 2
.
Symmetric to point
Use command
L
4
4 0
.