Owner's Manual

Programmer
135
Chaprter 3 Programming with Command Function
1
Programming
1. Press
P
.
The work clamp moves to the home position and the
programmer screen is displayed.
2. Move the work clamp with . Press
L
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
3. Create the program to point B.
4. Input point B and press
L
4
4 2
.
Input the command symmetric to Y axis.
5. The needle point moves slowly from point B
to point A in the right half and it is
automatically programmed. Press
to
make fast movement.
2
Inputting the end code
1. Press
E
1
1 1
when needle stops at
point A.
The work clamp returns to the start position.
3
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
4
Ending program
1. Press
P
.