Owner's Manual

Programmer
136
Chapter 3 Programming with Command Function
Splitting
Different patterns, splitting each pattern in sequence,
are programmed. The example in the left is used for
explanation of 3 patterns in sequence.
1
Programming
1. Press
P
.
The work clamp moves to the home position and the
programmer screen is displayed.
2. Move the work clamp with . Press
L
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
3. Program pattern 1.
4. Input point B and press
F
.
5. Move the work clamp with
. Press
L
6
6 6
when the needle point is at
point C of the pattern.
To change the pattern, press the pressure holder lift switch and
replace the pattern.
6. Program patterns 2 and 3.
2
Inputting the end code
1. Press
L
at the last stitch and press
E
1
1 1
.
The work clamp returns to the start position.
3
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
Pattern 1
Pattern 2
Pattern 1
Pattern 2