Owner's Manual

Chaprter 3 Programming with Command Function
Programmer
149
3
Programming a new point.
1. Press
F
.
2. Move the work clamp with
so that
the needle point is at 1' of the pattern.
Record the coordinates (values of and ).
3. Press
L
.
1' is programmed.
4. Move the work clamp with to the
opposite position of coordinates recorded
in step 2 and press
L
.
If the moving distance is long, press
LILI
.
5. Press
R
.
The work clamp returns to the home position.
4
Deleting 1
1. Press
1
and press .
The needle point returns to the first stitch.
2. Press
C
.
3. Input the number of stitches to be deleted
and press
.
The example is deleting 1 stitch. Press
1
.
4. The needle point moves to 1'.
5
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
6
Ending program
1. Press
P
.