Owner's Manual

Programmer
158
Chapter 3 Programming with Command Function
2
Moving to position 1
1. Press
9
9 9
and press .
The work clamp moves from the start point by each stitch.
2. Press when the needle is at 1.
The work clamp stops. If the work clamp passes, input a few
stitches and press
. The needle returns for a few stitches of
the input.
3
Moving in parallel
1. Press
7
7 7
and press
F
.
Input the command for parallel movement.
2. Move the work clamp with . Press
L
when the needle point is at 2 of the
pattern.
If pattern C is present after pattern B, pattern C is automatically
moved in parallel. If this is not preferred, move pattern C in
parallel as in steps
2
and
3
.
4
Saving
1. Specify the program number on the
operation panel and press the read/write
switch for writing into the floppy disk.
5
Ending program
1. Press
P
.