Owner's Manual

Programmer
166
Chapter 3 Programming with Command Function
Creating a zigzag circle (go to 6 when not creating a zigzag circle)
4. Input
M
7
(width).
5. Input the zigzag stitch length in 3 digits and press
M
.
6. Move the needle with to select the second point and press
L
.
Creating a circle (zigzag circle) by specifying the radius
Command to be used
LILI
2
3
Creating a circle clockwise. Input the overlap stitch counts in .
Values 0 - 9 are available for input.
LILI
2
4
Creating a circle counterclockwise. Input the overlap
stitchcounts in .
Values 0 - 9 are available for input.
M
7
Input this command to create a zigzag circle. Input the width of
zigzag in
.
"Creating a circle (zigzag circle) by specifying 3 points"
(Refer to page 163.)
M
Input this command to create a zigzag circle. Input the zigzag
stitch length in
.
"Creating a circle (zigzag circle) specifying 3 points"
(Refer to page 163.)
1. Select the sewing start position with and press
L
.