Owner's Manual

Programmer
170
Chapter 3 Programming with Command Function
Creating a zigzag stitch
Command to be used
M
7
Input this command to create a zigzag stitch. Input the width
of zigzag in . "Creating a circle (zigzag circle) by
specifying 3 points" (Refer to page 163.)
M
Input this command to create a zigzag stitch. Input the zigzag
stitch length in
. "Creating a circle (zigzag
circle) by specifying 3 points" (Refer to page 163.)
L
7
8 9
Carrying out zigzag stitch symmetrically to the sewing path.
L
7
8 8
Carrying out zigzag stitch on the left side to the sewing path.
L
7
8 7
Carrying out zigzag stitch on the right side to the sewing path.
1. Select the sewing start position with and press
L
.
2. Input
M
7
(width).
3. Input the stitch length in 3 digits and press
M
.
4. Move the needle with to select the second point, then press
L
.
5. Input
L
7
8 9
at the end position of the needle.
Input
L
7
8 8
for the left side and
L
7
8 7
for the right side.