Owner's Manual

Programmer
171
Chapter 3 Programming with Command Function
Creating a multiple stitch
Commands to be used
M
5
0 0
Input the start point for a multiple stitch.
M
5
Input the number of lines for a multiple stitch ranging from 2
to 99 in .
Ex.) The number of lines for a multiple stitch Input value
5 lines 505
M
Input the stitch length in .
L
7
8 9
Press
L
7
8 9
to input a split.
1. Determine the embroidering start point with and press
L
.
2. Press
M
5
0 0
.
3. Move the needle point to the second point or after with and
press
L
.
4. When the needle point is moved to the corner, press
L
7
8 9
.
5. Repeat steps 3 and 4 until the end point of the inside (or the outside) line
is input. Press
F
. Move the needle point to the start point of the outside
(or the inside) line with
, and press
L
.
6. Program all necessary points in the same manner.
7. Input the desired number of lines as
M
5
.
8. Input the desired stitch length as
M
.
9. Press
L
.