Owner's Manual

Programmer
173
Chapter 3 Programming with Command Function
Creating double stitch
Command to be used
M
2
Creating double stitch in the reverse direction to the sewing
path. Input the width of double stitch in .
Values 1.0 - 9.9 mm are available for the width.
Example Width Input
1.5 mm 215
M
Input the stitch length in .
L
7
8 9
Carrying out double stitch on the left side to the sewing path.
L
7
8 8
Carrying out double stitch on the right side to the sewing
path.
E
1
1
Starting double stitch calculations.
(This is the end code. Refer to page 179 for details.)
If sharp angles or fine curves are included in the pattern sheet, the desired double stitch may
not be achieved.
1. Select the sewing start position with
and press
L
.
2. Determine the width and input
M
2
.
3. Move the needle with to select the second point, then press
L
.
4. Move the needle to the corner point and input
L
7
8
.