Owner's Manual

Programmer
174
Chapter 3 Programming with Command Function
5. Repeat steps 3 and 4 and move the needle to the end point. Input
E
1
1
.
When the alarm sound is complete, the needle point moves to the end position.
Parallel stitch
Command to be used
M
3
Creating parallel stitch in the same direction to the sewing
path. Input the width of parallel stitch in .
Values 1.0 - 9.9 mm are available for the width.
Example Width Input
1.5mm 315
M
Input the stitch length in .
L
7
8 9
Carrying out parallel stitch on the left side to the sewing path.
L
7
8 8
Carrying out parallel stitch on the right side to the sewing
path.
E
1
1
Starting parallel stitch calculations.
(This is the end code. Refer to page 179 for details.)
1. Select the sewing start position with and press
L
.
2. Determine the width and input
M
3
.
3. Move the needle with to select the second point, then press
L
.