Owner's Manual

Programmer
175
Chapter 3 Programming with Command Function
4. Move the needle to the corner point and input
L
7
8
.
5. Repeat steps 3 and 4 and move the needle to the end point. Input
E
1
1
.
When the alarm sound is complete, the needle point moves to the end position.
Offset
Command to be used
M
4
Creating offset. Input the width of offset in .
Values 1.0 - 9.9 mm are available for the width
Example Width Input
1.5 mm 415
M
Input the stitch length in .
L
7
8 9
Carrying out offset on the left side to the sewing path.
L
7
8 8
Carrying out offset on the right side to the sewing path.
E
1
1
Starting offset calculations.
(This is the end code. Refer to page 179 for details.)
1. Select the sewing start position with and press
L
.
2. Determine the width and input
M
4
.