Owner's Manual

Programmer
177
Chapter 3 Programming with Command Function
3. Input command depending on the feed.
Press
L
if not specified.
Creating split data
Command to be used
L
2
2 0
Stopping the needle at the upper end for the split.
L
2
2 1
Stopping the needle at the lower end for the split.
1. Input command depending on the split.
Creating magnified data
Command to be used
M
9
0 2
Input for magnification (x2)
M
9
0 5
Input for magnification (x5)
M
9
1 0
Input for magnification (x10)
The following three scales are available for magnification: x2, x5, and x10.
Use a pattern sheet suitable for the magnified pattern.
The magnified data is reduced when the end code is input.
1. Make sure that the needle is at the home position.
Press
R
if not specified.
2. Select magnification and press
M
9
.