Owner's Manual

Programmer
183
Chapter 3 Programming with Command Function
Copying a pattern rotated clockwise (counterclockwise)
Command to be used
M
6
7 6
Copying a pattern rotated clockwise
M
6
7 7
Copying a pattern rotated counterclockwise
This function is available only when the needle is at the home position.
Values of 1 - 359 degrees are available for input.
The copied data is linked to the original data with a split data.
1. Make sure that the needle is at the home position.
Press
R
if the needle is not at the home position.
2. Determine the center point for rotation with .
3. Input
M
6
7 6
or
M
6
7 7
.
4. Input the angle in 3 digits and press
L
.