Owner's Manual

Programmer
184
Chapter 3 Programming with Command Function
Resizing
Command to be used
M
8
8 8
Resizing a pattern in the X and Y directions
F
Used to input magnification in the X direction.
M
Used to input magnification in the Y direction.
This function is available only when the needle is at the home position.
1. Make sure that the needle is at the home position.
Press
R
if the needle is not at the home position.
2. Determine the reference point for resizing with .
3. Input
M
8
8 8
.
4. Input the magnification in 3 digits in the X direction and press
F
.
Magnification values of 0 - 400 are available for input.
5. Input the magnification in 3 digits in the Y direction and press
M
.
Magnification values of 0 - 400 are available for input.