Owner's Manual

Programmer
185
Chapter 3 Programming with Command Function
6. Input the stitch length in 3 digits and press
L
.
If the value is "000", the stitch count remains unchanged. The stitch length increases or decreases.
Copying a pattern resized
Command to be used
M
9
9 9
Copying a pattern resized in the X and Y directions
F
Used to input magnification in the X direction.
M
Used to input magnification in the Y direction.
This function is available only when the needle is at the home position.
The copied data is linked to the original data with a split data.
1. Make sure that the needle is at the home position.
Press
R
if the needle is not at the home position.
2. Determine the reference point for resizing with .
3. Input
M
9
9 9
.
4. Input the magnification in 3 digits in the X direction and press
F
.
Magnification values of 0 - 400 are available for input.