Owner's Manual

Programmer

205

Chapter 4 Extended Option Output

Table of extended option output

Extended option

Common output (condition) *1 Connector *2

output No.

Part name Condition

Connector No.

No.

1 2 stage tension Memory SW-0b ON 5

2 Air wiper Memory SW-09 ON 6

Pattern engraving drill Memory SW-10 ON P4(AIR) 6

3 Auto eject Memory SW-03 ON 7

Upper/lower engraving Memory SW-10 ON 7

4 Right work clamp turnover Memory SW-19 ON 1

5 Left work clamp turnover Memory SW-19 ON 2

6 3

7 P21(EXOUT) 4

8 5

9 Signal tower green Memory SW-15 ON 6

10 Signal tower yellow Memory SW-15 ON 7

11 Signal tower red Memory SW-15 ON 8

12 NEEDLE DIPSWB-4 ON 8

13 FLIP DIPSWA-6 ON 4

14 FOOT DIPSWC-6 ON P4(AIR) 3

15 LCLAMP When 2 stage pressure 2

bar is used

16 RCLAMP For the air type 1

Input available for optional parts. It is not used as extended option input if conditions are met.

Connector number and pin number on the main circuit board in the control box

・The common terminal of connector P4 (AIR) is pin No. 11 at +24V.

・The common terminal of connector P21 (EXOUT) is pin No. 9 or 10 at +24V.