Owner's Manual

Programmer
210
Chapter 5 Reading/Writing Data
Reading data
Reads data from a floppy disk.
When there is no data for creation, data can be read by pressing by pressing the R/W button
on the operation panel.
This operation cannot be available in command mode.
Data created in BAS-300 and BAS-300A series can also be read.
1. Select
and press .
2. Make sure that is selected, and press .
3. Input the number of program with a numeric key.
If there is data, appears.
If there is no data,
appears. If appears, the data is from BAS-300 or BAS-300A series.