Owner's Manual

Programmer
35
Chapter 2 Programming with Help Function
7. Move the work clamp with . Press
twice when the needle point is at point B
of the pattern.
8. Program points C, D and E.
9. When point E is programmed, press
again.
10. Program point F.
11. When point F is programmed, press
again.
12. Press
.
The needle moves to points F, G and H.
13. When the needle stops, press

ESCESC
three
times.
2
Inputting the end code
1. Select with and press .
2. Select the end code type with and
press
.
"111" is selected in the example. Press and the work clamp
returns to the first stitch(point A).
3. Press

ESCESC
.
The work clamp returns to the home position.