Owner's Manual

Programmer
51
Chapter 2 Programming with Help Function
10. Program the following points up to point #4
in the same manner.
When programming, be sure that the points and splits specified
on the inside line are paired with those on the outside line
respectively.
If there are any points or splits not paired, the needle point
automatically returns to the previous point. Correct the program.
11. Press .
12. Press

ESCESC
.
3
Inputting the end code
1. Select with and press .
2. Select the end code type with
and
press
.
"111" is selected in the example. Press and the work clamp
returns to the first stitch(point A).
3. Press

ESCESC
.
The work clamp returns to the home position.
4
Saving
1. Select with and press .
2. Select
with and press .
3. Input the data number and press
.
4. Press

ESCESC
.
5
Ending program
1. Press
P
.