Owner's Manual

Programmer
79
Chapter 2 Programming with Help Function
3. When the needle point reaches 1, press .
The work clamp stops. If the work clamp passes, input a few
stitches and press
. The needle returns for a few stitches of
the input.
4. Press

ESCESC
.
3
Moving in parallel
1. Select with and press .
2. Select
with and press .
3. Move the work clamp with
. Press
when the needle point is at 2.
Move 3 to 4 in the similar manner.
4. Press

ESCESC
three times.
4
Saving
1. Select with and press .
2. Select
with and press .
3. Input the data number and press
.
4. Press

ESCESC
.